Stuart Turner Monsoon Extra S3.0 bar Single - Manual (Page 8)

- 8 -
4. Push pipe firmly into fitting, until pencil mark is level with the top of the collet and the
pipe stop resistance is felt. Pull on pipe to check it is secure and correctly fitted.
5. To release the joint, push pipe firmly into fitting, hold the collet down and gently
remove pipe. If the system has been filled with water, care should be taken to isolate
pump and towels used to absorb spilled water.
If you have any concern either about using push-in fittings or should the joint leak on final
test isolate the water supplies and contact Pump Assist on 0844 98 000 97.
3. Check in the mouth of the fitting that ‘O’-ring, nylon washer and collet are in
position.
Cont ...
Fig. 11
Pipe Stop
Washer
Collet
‘O’-Ring