Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 387)

Multi-Service IronWare Administration Guide 369
53-1003028-02
Syslog messages
A
Notification ISIS LSP-type LSP LSP-ID Seq
sequence-number Len length LifeTime
lifetime on interface-name dropped due to
LSP-drop-reason The device has dropped the received LSP.
The LSP-Type can be one of the following:
•
L1
•
L2
The LSP-ID variable is in the 8 byte LSP ID
value.
The sequence-number is a 4 byte value that
is associated with each LSP ID.
The length is the length of the LSP PDU.
The lifetime is the life period of the LSP.
The interface-name is the name of the
interface and is displayed in the following
form “Ethernet 1/1”.
The LSP-drop-reason variable describes the
following reasons that the LSP was
dropped:
•
Adjacency not found
•
Adjacency Level Mismatch
•
IS Level Mismatch
•
Length Too Short
•
Length Too Large
•
Authentication Failure
•
Max Area Check Failure
•
Zero Checksum
•
Checksum Mismatch
•
Invalid Length
Definitions of the LSP-drop-reason values
are described in
Table 75 .
Notification ISIS NbrType Neighbor
Hostname/systemID DOWN on
interface-name due to
neighbor-down-reason The device’s Neighbor has gone down.
The NbrType can be one of the following:
•
L1
•
L2
•
PTPT
The interface-name is the name of the
interface and is displayed in the following
form “Ethernet 1/1”.
The neighbor-down-reason variable can be
any one of the following reasons that the
Neighbor is Down:
•
BFD Trigger
•
Maximum Adjacencies
•
User Trigger
•
Hold Timer Expiry
•
Adjacency ID Mismatch
•
Adjacency Type Mismatch
•
Interface Down
•
Interface State Change
Definitions of the neighbor-down-reason
values are described in
Table 75 .
TABLE 74 Syslog messages IS-IS (Continued)
Message level Message Explanation