Brocade TurboIron 24X Series Configuration Guide - Manual (Page 1091)

Brocade TurboIron 24X Series Configuration Guide 1057
53-1003053-01
Syslog messages
Informational MAC Based Vlan Disabled on port <port id> A MAC Based VLAN has been disabled on a
port
Informational MAC Based Vlan Enabled on port <port id> A MAC Based VLAN has been enabled on a
port.
Informational MAC Filter added | deleted | modified from
console | telnet | ssh | web | snmp session
filter id = <MAC filter ID>, src mac = <Source
MAC address> | any, dst mac = <Destination
MAC address> | any A user created, modified, deleted, or
applied this MAC filter through the Web,
SNMP, console, SSH, or Telnet session.
Informational MSTP: BPDU-guard interface ethernet
<port-number> detect (Received BPDU),
putting into err-disable state. BPDU guard violation occurred in MSTP.
Informational OPTICAL MONITORING: port <port-number>
is not capable. The optical transceiver is qualified by
Brocade, but the transceiver does not
support digital optical performance
monitoring.
Informational Port <p> priority changed to <n> A port priority has changed.
Informational Port <portnum>, srcip-security
max-ipaddr-per-int reached.Last
IP=<ipaddr> The address limit specified by the
srcip-security max-ipaddr-per-interface
command has been reached for the port.
Informational Port <portnum>, srcip-security
max-ipaddr-per-int reached.Last
IP=<ipaddr> The address limit specified by the
srcip-security max-ipaddr-per-interface
command has been reached for the port.
Informational Security: console login by <username> to
USER | PRIVILEGE EXEC mode The specified user logged into the device
console into the specified EXEC mode.
Informational Security: console logout by <username> The specified user logged out of the device
console.
Informational Security: telnet | SSH login by <username>
from src IP <ip-address>, src MAC
<mac-address> to USER | PRIVILEGE EXEC
mode The specified user logged into the device
using Telnet or SSH from either or both the
specified IP address and MAC address. The
user logged into the specified EXEC mode.
Informational Security: telnet | SSH logout by <username>
from src IP <ip-address>, src MAC
<mac-address> to USER | PRIVILEGE EXEC
mode The specified user logged out of the device.
The user was using Telnet or SSH to access
the device from either or both the specified
IP address and MAC address. The user
logged out of the specified EXEC mode.
Informational SNMP read-only community | read-write
community | contact | location | user |
group | view | engineld | trap [host] [<value
-str>] deleted | added | modified from
console | telnet | ssh | web | snmp session A user made SNMP configuration changes
through the Web, SNMP, console, SSH, or
Telnet session.
[<value-str>] does not appear in the
message if SNMP community or engineld is
specified.
Informational SNMP Auth. failure, intruder IP: <ip-addr> A user has tried to open a management
session with the device using an invalid
SNMP community string.
The <ip-addr> is the IP address of the host
that sent the invalid community string.
TABLE 176 Brocade Syslog messages (Continued)
Message level Message Explanation