Brocade TurboIron 24X Series Configuration Guide - Manual (Page 248)

214 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Digital optical monitoring
Media not supported
Digital optical monitoring is not supported for the following optics:
• 1000Base-SX 2
• 1000Base-BX-D
• 1000Base-BX-U
• E1MG-100BXU
• E1MG-100BXD
• E1MG-BXU
• E1MG-BXD
Supported media
Digital optical monitoring is supported with the following Brocade-qualified media types:
• 1000Base-BX-D
• 1000Base-BX-U
• 1000Base-LHA
• 1000Base-LHB
• 1000Base-LX
• 1000Base-SX
• 1000Base-SX 2
Media not supported
Digital optical monitoring is not supported for the following optics:
• E1MG-100BXU
• E1MG-100BXD
• E1MG-BXU
• E1MG-BXD
Configuration limitations
A device can monitor a maximum of 24 SFPs and 12 XFPs.
Enabling digital optical monitoring
To enable optical monitoring on all Brocade-qualified optics installed in the device, use the
following command.
TurboIron(config)#optical-monitor
To enable optical monitoring on a specific port, use the following command.
TurboIron(config)#interface ethernet 1
TurboIron(config-if-e10000-1)#optical-monitor