Brocade Fabric OS Encryption Administrator’s Guide Supporting NetApp Lifetime Key Manager (LKM) and KeySecure Storage Secure Key Manager (SSKM) Environments (Supporting Fabric OS v7.2.0) - Manual (Page 53)

Fabric OS Encryption Administrator’s Guide (LKM/SSKM) 35
53-1002925-01
Creating an encryption group
2
2. Select a switch from the <NO GROUP DEFINED> encryption group. (The switch must not be
assigned to an encryption group.)
3. Select Encryption > Create/Add to Group, from the menu task bar.
The Configure Switch Encryption wizard welcome screen displays. (Refer to Figure 17 .) The wizard
enables you to create a new encryption group, or add an encryption switch to an existing encryption
group. The wizard also enables you to configure switch encryption.
Click Next on each screen to advance to the next step in the wizard. Steps might vary slightly
depending on the key vault type selected, but the basic wizard steps are as follows.
a. Designate Switch Membership.
b. Create a new encryption group or add a switch to an existing encryption group.
c. Select the key vault.
d. Specify the public key filename.
e. Select Security Settings.
f. Confirm the configuration.
g. Configuration Status.
h. Read Instructions.
FIGURE 17 Configure Switch Encryption wizard - welcome screen