Figure 448 – Brocade Network Advisor SAN User Manual v12.1.0 User Manual
Page 1119
1072
Brocade Network Advisor SAN User Manual
53-1002948-01
Adding a policy monitor
32
FIGURE 448
Add Policy Monitor dialog box, Switch/Router Checks tab
a. Select one or more of the following checks in the Available Checks list to include them in
the policy monitor:
For more information about these checks and fixes for rule violations, refer to
•
Select the Check if the product is configured to send events to this server check to
determine if the Management application server is registered as an SNMP recipient
and Syslog recipient.
•
Select the Check for redundant connections to neighboring switches (SAN only) check
to determine if there are at least the minimum number of configured ISLs between
each switch pair.
•
Select the Check for HTTPS (secure HTTP) configuration check to check each target to
see if HTTPS is active for device data transmission.
•
Select the Check if the product is configured to send Upload Failure Data Capture to
an FTP server (SAN only) check to determine the following configurations:
– Upload Failure Data Capture is enabled on the selected switches.
– A configured FTP Server is accessible.
– You have write permission to the directory.
•
Select the Check for SSH (secure Telnet) configuration check to check each target to
see if SSH is enabled for device data transmission.
•
Select the Check for SNMPv3 (secure SNMP) configuration check to check each target
to see if SNMPv3 is active for device data transmission and SNMPv1 and SNMPv2 are
not configured.
b. Click the right arrow button to move the selected checks to the Selected Checks list.