Brocade Network Advisor SAN User Manual v12.1.0 - Manual (Page 982)

934 Brocade Network Advisor SAN User Manual
53-1002948-01
Spanning Tree Protocol configuration
26
Configuring STP or RSTP on a port VLAN
You can configure Spanning Tree Protocol (STP) and Rapid Spanning Tree Protocol (RSTP) attributes
from the VLAN View tab or the Product View tab on the VLAN Manager dialog box.
NOTE
The VLAN View tab displays VLAN membership information for the IronWare OS 6910 switch;
however, STP configuration is not supported on the IronWare OS 6910 switch.
1. Perform one of the following tasks to select the VLAN on which STP or RSTP will be configured:
• On the VLAN View tab, expand the list of VLANs and select one or multiple VLANs on which
STP or RSTP will be configured.
• On the Product View tab, expand the product, product group, or IP subnet folder that
contains the products on which the VLAN you want is configured. Then expand the entry to
display its VLAN and select the VLAN where STP or RSTP will be configured. You can select
more than one VLAN from this tab.
For either view, you can use the Search tool to look for the VLAN on which STP or RSTP will be
configured.
NOTE
The parameters display differently depending on whether the STP configuration is at the
product, VLAN, or port level.
Either of these methods enables the STP button on the VLAN Manager dialog box.
2. Click the STP button on the VLAN Manager dialog box to display the STP Configuration dialog
box ( Figure 408 ).
The products on which the VLAN is configured appear on the dialog box.
FIGURE 408 STP Configuration dialog box
3. Select the target switch, VLAN, or port from the Target Context list. Target contexts and
spanning tree options at the product, VLAN, or port level are listed in Table 76 .