Brocade Network Advisor SAN User Manual v12.1.0 - Manual (Page 170)

120 Brocade Network Advisor SAN User Manual
53-1002948-01
Software Configuration
5
Default values for SAN only Server
Server Heap Size
For a 32-bit Windows/Linux Server
• Small : 768 MB
• Medium : 1024 MB
• Large : 1024 MB
For all 64-bit servers, the default minimum Server Heap Size for all network sizes is 2048 MB.
NOTE
There is no restriction on the maximum value for Server Heap Size in a 64-Bit Server. The
correct server heap size value must be given according to the RAM present in the server.
6. Click Apply or OK to save your work.
NOTE
Changes to this option take effect after an application restart.
NOTE
You can only restart the server using the Server Management Console (Start > Programs >
Management_Application_Name 12.X.X > Server Management Console).
7. Click OK on the “changes take effect after application restart” message.
Configuring asset polling
Asset polling allows you set the length of time between state change polling. To maximize the
efficiency of the polling feature (balance the amount of possible information with any possible
performance impact), base your settings on the size of the SAN.
To configure asset polling, complete the following steps.
1. Select Server > Options.
The Options dialog box displays.
2. Select Memory Allocation in the Category list to set the memory allocation for the server and
client.
The Memory Allocation pane displays.
3. Enter how often you want to check for state changes in the Check for state change every field.
Valid values are from 1 through 600 seconds. You cannot enter a value lower than the default
minimum value.
Default minimum values are as follows:
• Small (Professional): 60 seconds
• Medium: 120 seconds
• Large: 180 seconds