Brocade Network Advisor SAN User Manual v12.1.0 - Manual (Page 704)

656 Brocade Network Advisor SAN User Manual
53-1002948-01
Creating a new encryption group
20
After configuration of the encryption group is completed, the Management application sends
API commands to verify the switch configuration. See
“Understanding configuration status
results” on page 673 for more information.
11. Review important messages, then click Next.
The Next Steps dialog box displays. (Refer to Figure 267 .) Instructions for installing public key
certificates for the encryption switch are displayed.
FIGURE 267 Next Steps dialog box
12. Review post-configuration instructions, which you can copy to a clipboard or print for later.
13. Click Finish to exit the Configure Switch Encryption wizard.
14. Refer to “Understanding configuration status results” on page 673.