Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1295)

Brocade Network Advisor SAN User Manual 1243
53-1003154-01
Adding a configuration policy manager
31
The selected fabrics display in the Selected Fabrics list.
7. To set configuration policy managers for switches, select the Switch/Router Checks tab
( Figure 531 ) and complete the following steps.
FIGURE 531 Add Configuration Policy Manager dialog box, Switch/Router Checks tab
a. Select one or more of the following checks in the Available Checks list to include them in
the configuration policy manager:
For more information about these checks and fixes for rule violations, refer to “Switch and
router configuration policy managers” on page 1233.
• Select the Check if the product is configured to send events to this server to
determine if the Management application server is registered as an SNMP recipient
and syslog recipient.
• Select the Check for redundant connections to neighboring switches (SAN only) check
box to determine if there are at least the minimum number of configured ISLs
between each switch pair.
• Select the Check for HTTPS (secure HTTP) configuration check box to check each
target to see if HTTPS is active for device data transmission.
• Select the Check if the product is configured to send Upload Failure Data Capture to
an FTP server (SAN only) check box to determine the following configurations:
– Upload Failure Data Capture is enabled on the selected switches.
– A configured FTP Server is accessible.
– You have write permission to the directory.
• Select the Check for SSH (secure Telnet) configuration check box to check each target
to see if SSH is enabled for device data transmission.