Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 897)

Brocade Network Advisor SAN User Manual 845
53-1003154-01
Master keys
20
6. Re-enter the passphrase for verification, then click OK.
A dialog box displays that shows the Key ID. The Key ID identifies the storage location in the
key vault.
7. Store both the Key ID and the passphrase in a secure place. Both will be required to restore the
master key in the future.
8. Click OK. after you have copied the Key ID.
Saving a master key to a smart card set
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 266 on page 694.)
2. Select a group from the Encryption Center Devices table, then select Group > Security from the
menu task bar.
The Encryption Group Properties dialog box displays with the Security tab selected.
3. Select Backup Master Key as the Master Key Action.
The Backup Master Key for Encryption Group dialog box displays. (Refer to Figure 397 .)
FIGURE 397 Backup Master Key for Encryption Group dialog box - Backup Destination to smart cards
4. Select A Recovery Set of Smart Cards as the Backup Destination.
5. Enter the recovery card set size.
6. Insert the first blank card and wait for the card serial number to appear.
7. Run the additional cards through the reader that are needed for the set. As you read each card,
the card ID displays in the Card Serial# field. Be sure to wait for the ID to appear.