Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 737)

Brocade Network Advisor SAN User Manual 685
53-1003154-01
Configuring Virtual Fabrics
19
Finding the physical chassis for a logical switch
The Management application enables you to locate the physical chassis in the Product List from
which the logical switch was created.
To find the physical chassis for a logical switch, right-click the logical switch in the Connectivity Map
or Product List and select Virtual Fabric > Chassis.
The physical chassis is highlighted in the Product List.
Finding the logical switch from a physical chassis
The Management application enables you to locate the logical switch from the physical chassis.
1. Expand the Chassis Group node in the Product List.
2. Right-click the physical chassis within the Chassis Group.
3. Select Virtual Fabric > Logical Switches > Logical_Switch_Name.
The logical switch you selected is highlighted in the Product List and Connectivity Map.
Assigning ports to a logical switch
When you create a logical switch, it has no ports and you must explicitly assign ports to it.
When you assign a port to a logical switch, it is removed from the original logical switch and
assigned to the new logical switch. All ports are initially assigned to the default logical switch.
A port can be assigned to only one logical switch.
1. Select Configure > Virtual Fabric > Logical Switches.
The Logical Switches dialog box displays.
2. Select the physical chassis from which you want to assign ports in the Chassis list.
3. (Optional) Select the Addressing check box to specify the starting port address for the ports
that will be moved.
If this check box is cleared, the port addresses are set to “unassigned”. The ports are assigned
a system-generated port address when they are configured on the destination logical switch.
This option is supported only for FC ports in zero-based addressing mode or 10-bit addressing
mode.
4. (Optional) Select the Port Configurations check box to clear the port configurations prior to the
move.
Clearing the port configurations ensures that the port move is not blocked by
configuration-related validation checks.
5. Select the ports you want to include in the logical switch from the Ports list.
You can configure the Ports list by selecting Table View (list of all ports) or Tree View (list of
ports grouped by slot) from the Display list.
6. Select the logical switch in the Existing Logical Switches list.
To see all of the items in the Existing Logical Switches list, you can right-click anywhere in the
list and select Table > Expand All.