Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1316)

1264 Brocade Network Advisor SAN User Manual
53-1003154-01
SNMP traps
32
FIGURE 539 SNMP Trap Forwarding dialog box
Adding a trap destination
The Add Trap Destination dialog box allows you to configure destinations for forwarding SNMP
traps.
To add a trap destination, complete the following steps.
1. Select Monitor > SNMP Setup > Trap Forwarding.
The SNMP Trap Forwarding dialog box, shown in Figure 539 , displays.
2. Select the Enable trap forwarding check box.
3. Click Add in the Destinations area of the SNMP Trap Forwarding dialog box.
The Add Trap Destination dialog box, shown in Figure 540 , displays.