Brocade Virtual ADX Graphical User Interface Guide (Supporting ADX v03.1.00) - Manual (Page 259)

Brocade Virtual ADX Graphical User Interface Guide 247
53-1003242-01
Packet capture
19
4. In the Packet Capture Summary tab, choose the Edit Filter button to display the Edit Filter tab.
FIGURE 171 Packet Capture - Edit Filter tab
Use the Edit Filter tab to configure packet capture and set parameters for the following filters:
• MAC Filter
• IP Filter
• ICMP Filter
• IPv6 Filter
• ICMPv6 Filter
• TCP Filter
• UDP Filter
• Pattern Filter
Click the Apply button in the lower right hand corner of the Edit Filter tab to apply filter properties.
Click the Reset button in the lower right hand corner of the Edit Filter tab to reset filter properties.
Apply packet capture
Take the following steps within the Maintain tab to apply packet capture:
1. Select the Maintain tab.
2. Click Tools on the menu bar.
3. From the sidebar, select Packet Capture to display the Packet Capture Summary tab.