Brocade Virtual ADX Graphical User Interface Guide (Supporting ADX v03.1.00) - Manual (Page 264)

252 Brocade Virtual ADX Graphical User Interface Guide
53-1003242-01
CLI access
20
3. Enter the CLI commands in the field under the Enter a batch of up to 10 CLI commands that
you would like to send to the Brocade Virtual ADX.
NOTE
The maximum number of CLI Commands that you can run from the web interface is 10.
However, if any command fails to execute, the Brocade Virtual ADX will continue to process the
remaining commands and return the response of the commands that are executed.
NOTE
The rconsole command is not supported via the CLI Access page.
4. Perform one of the following actions:
• Click Send to run the commands on the Brocade Virtual ADX and view the response from
the Brocade Virtual ADX under Results.
• Click Clear to clear the command entries.
NOTE
The CLI commands will be validated only on the Brocade Virtual ADX and not on the client.
NOTE
You can run show, configuration, and copy or paste commands from the web interface.
However, you cannot run the boot and reset commands.