Actiontec electronic GE344000-01 - Manual (Page 60)

57
Appendix B Configuring TCP/iP
18. Restart the computer. After the computer restarts, verify the settings. Click
Start, Programs and Command Prompt. At the command prompt, enter:
ipconfig /all
Verify an IP address was received, then close the window.
Windows 2000
Windows 2000 installs with default TCP/IP configuration. If the computer is new
with Windows 2000 installed, or Windows 2000 has just been installed on the com-
puter, connect the computer to the Router. No further configuration is necessary.
If the Windows 2000 TCP/IP settings on the computer have been changed since
installation, the TCP/IP settings must be configured. If this is the case, ensure the
Windows 2000 installation disks or CD-ROM is available before beginning, since
some driver information may need to be copied during the configuration process.
If the installed Ethernet adapter was supplied with a driver diskette, it should be
available as well.
☞
Note: When installing any software, consult the user guide and
help files supplied with the software for detailed information.
Actiontec provides the following information as a guideline only.
To configure Windows 2000 TCP/IP settings:
1. Click Start, Settings and Control Panel.
2. When the “Control Panel” window appears, double-click Network and Dial-
Up Connections.