Hired-Hand Evolution Series Bird Scale Manual - Manual (Page 31)

Part n° 890-00487 rev.00 Evolution Bird Scale Controller 31
9. Password
Enter password:
00 ** **
9. Password
Current mode:
User 1
5.7. Installation settings
The installation chapter shows how to customize the controller for your
particular application. Normally, this setup needs to be done only once.
Note that installation menus are only available from the installer mode:
enter the installer password as shown below.
5.7.1 Entering Password
For security reasons, a password is required to access the installation mode.
The password is made up of three blocks of two digit. By default, the
installer password is set to 03 05 14. The password cannot be changed.
Select the "9. Password" menu
from the main menu then press
the right-arrow key. The current
mode is displayed.
Press the right-arrow key once
again. The first two digits of the
password flash on the display.
Use the adjustment buttons to set
the first two digits of the pass-
word. Press the right-arrow key.
Proceed the same way to set the second and third two digits. Press
the right-arrow key to validate the password. If the password entered
is incorrect, the message "Wrong Password" is displayed.