Hired-Hand Evolution Series Bird Scale Manual - Manual (Page 43)

Part n° 890-00487 rev.00 Evolution Bird Scale Controller 43
MEMORY CARD CONTROLLER:
To transfer the memory card's content
into the controller, select the
"Mem.Card Ctrl". Once it is se-
lected, simultaneously press the +and
- buttons to start the transfer.
CONTROLLER MEMORY CARD:
To save the controller's configuration
into the memory card, select the "Ctrl
Mem.Card " menu. Once it is se-
lected, simultaneously press +and - but-
tons to start the transfer.
7. Once the transfer is over, simultaneously
press and hold the up- and down-arrow
keys for 5 seconds to exit the transfer
menu, then remove the memory card from
the connector as follows:
- Turn off power to the controller;
- Open the controller's cover;
- Remove the card from the connector;
- Close the cover then reapply power to
the controller.
8. Lock the card’s switch ( ) if required.
TRANSFER ERROR
The controller will not warn you if the transfer is incorrect.
Respect the following rules to make sure the transfer works properly:
• Make sure the card switch is at the unlocked position before
transferring a configuration on the card.
• Do not move or hold the card while a transfer is ongoing.
Ctrl –> Mem. Card
+/- to start
Mem.Card –> Ctrl
+/- to start
IMPORTANT:
REMOVE THE
MEMORY CARD
FROM THE
CONNECTOR WHEN
THE TRANSFER
IS OVER!