Hired-Hand Evolution Series Bird Scale Manual - Manual (Page 42)

Part n° 890-00487 rev.00 Evolution Bird Scale Controller 42
7. MEMORY CARD
The memory card is used to create a backup copy of your controller's
configuration. The card is also useful to transfer the configuration of one
controller to another controller of the same type.
The switch at the bottom of the card is used to lock or to unlock the card
( = locked, = unlocked).
Turn off power each time you open the controller's enclosure.
This prevents accidental exposure to areas of high voltage.
TO TRANSFER A CONFIGURATION:
1. Turn off power to the controller.
2. Open the latch and lift the
controller's cover.
3. If you are about to copy the
controller's configuration on the
memory card, make sure the card's
switch is at the unlocked position.
4. Insert the card in the J9 connector
located on the electronic board in-
side the controller. Components of
the memory card must face down
as illustrated.
5. Close the cover then reapply power to the controller. The transfer
menu should be shown on screen (if this is not the case, simultaneously
press the up- and down-arrow keys for 3 seconds to display this menu).
6. Use the up- and down-arrow keys to select the proper type of transfer:
Memory Card
Card Switch
Electronic
Board
Connector
J9