Hired-Hand Evolution Series Bird Scale Manual User Manual
Page 6
Part n° 890-00487 rev.00
Evolution Bird Scale Controller
6
1.
INTRODUCTION
1.1 Precautions, Care & Maintenance
WARNING:
Read and save
these instructions!
Safety may be jeopardized if the equipment is used in a manner not speci-
fied by the manufacturer. Carefully read and keep the following instruc-
tions for future reference.
•
Although fuses at the input and outputs of the controller protect its
circuits in case of an overload or overvoltage, we recommend install-
ing an additional protection device on the controller's supply circuit.
•
The room temperature where the controller is located must always
remain between 32 °F and 104 °F (0 °C to 40 °C). For Indoor use
only !
•
To avoid exposing the controller to harmful gases or excessive humidity,
it is preferable to install it in a corridor.
•
Do not spray water on the controller! In order to clean the control,
wipe it with a damp cloth.
Before servicing or cleaning unit, switch power off at service
panel and lock the switch disconnecting means to prevent
power from being switched accidentally. When the service
disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
•
The controller should be opened and inspected once a year for mois-
ture. Proper care will extend the life of the control.