Hired-Hand RS-400 Door - Manual (Page 12)

Part No. 4801-5170 Rev 5/08 RS 400 Door Page 12 of 26
1004-7029
Diagram 7
Chain Hoist
5.6.4 Chain Hoist Installation
Chain Hoist can be installed on left or right side of door.
1. Remove the Safety Bracket only on the side of the door where the hoist is to be installed. Retain bracket
and hardware for later use. See Section 5.6.3.
2. On shaft end of door, position U-shaped mounting bracket (6421-9393) over shaft.
3. Align bolt holes of bracket with attachment holes in door.
4. Insert bolts through cut-out openings of mounting bracket.
5. Securely attach mounting bracket to door.
6. Position Chain Hoist (6421-9339) onto mounting bracket. Align bolt holes of Chain Hoist with holes in
mounting bracket.
7. Securely fasten Chain Hoist to bracket with bolts provided.
8. Securely attach Catch Bracket to wall with self-tapping screws provided.
9. Securely hook chain into Catch Bracket as shown below.
10. Remove the Safety Bracket on the opposite side of the door from the hoist. Retain bracket and hardware
for later use. See Section 5.6.3.
11. Hoist installation complete. See Section 6 for Door Operation.
Warning!
NEVER RELEASE CHAIN!
If Chain Is Released, Door Will Drop With Rapid Motion. Injury May Occur If Chain Is Released!
Attach Catch Bracket* with
two self-tapping screws
(1004-0050). (*Appearance
may vary)
6421-9393
Brkt .
6421-9339
1004-6021
!