Seca 959 - Manual (Page 62)

62 •
Fastening the weighing
cell cable
ATTENTION!
Malfunction due to assembly error
If the cables are assembled so that they are
under voltage, e.g. if they are bent sharply or
plugs are snapped off, this can cause faulty dis-
plays and failure of the display.
– Lay all cables so that they are not too sharply
bent and so that plugs are not snapped off.
– Ensure that there is strain relief by laying all
cables in the appropriate harnesses.
 Press the cable clips (fastened at the factory to the
weighing cell cable) into the holes on the lower
frame and on the handle until they snap in audibly.