Spectra Precision Survey Pro CE v3.60 GPS User Manual - Manual (Page 110)

Job Menu
15
Radio Communications Screen
-RE 6HWWLQJV 5HFHLYHU 5HFHLYHU 6HWWLQJV %DVH 5DGLR &RQILJXUH 6HULDO
-or-
-RE 6HWWLQJV 5HFHLYHU 5HFHLYHU 6HWWLQJV 5RYHU 5DGLR &RQILJXUH 6HULDO
The Radio Communications screen is used to change the settings for
communication between the base or rover receiver and the radio.
Baudrate : is where you select the baud rate
the receiver will use to communicate with the
radio.
Parity : When selectable, is where you select
the parity the receiver will use to
communicate with the radio.
Serial Port (GPS Receiver) : is where you
select the serial port the receiver will use to
communicate with the radio.
'HIDXOWV : automatically sets all the selectable values to their
defaults based on the selected hardware.
5HFHLYHU 6HW : sets the selected radio communication settings in the
receiver.
Note: The radio communication settings are also set in the receiver
during the base and rover setup procedure. Therefore, you will not
usually have to use the Receiver Set button on this page.