Spectra Precision Survey Pro CE v3.60 GPS User Manual - Manual (Page 92)

GPS User’s Manual
88
o You attempt to change the radio channel on a radio that supports
software breaks and you are still prompted to toggle the power on
and off.
¾ The radio baud rate is not set at the correct value for this
radio. Make sure the radio baud rate is set correctly and
try again.
Base Setup
o You attempt to get an autonomous position from the base receiver
and you get the message: "
Not enough satellites for solution. Try
again. "
¾ Check to make sure the antenna is connected.
¾ Check the Sky View card on the GPS Status screen to
make sure you are tracking satellites.
o
You attempt to get or set the base or rover and you get the
message: “
Survey Pro could not execute that command in the
receiver. Check receiver settings and communication and try again. ”
¾ Check to see if you are communicating with the receiver.
Check the GPS Status screen and make sure you are not
getting the
No COM message on any of the cards.
¾ The receiver may be busy doing other things. If you
attempt to set the receiver when it is still doing a cold
start, it will not respond to all commands.
Radio Communication
o You set up the base and the Tx. Light on the base radio is not
blinking at a regular rate.
¾ Make sure the radio serial cable is connected.
¾ Make sure the radio antenna is connected.
¾ Make sure the base radio COM port and baud rate is
correct.