Spectra Precision Survey Pro CE v3.60 GPS User Manual - Manual (Page 169)

GPS Reference Manual
74
Stake Points
6WDNHRXW 6WDNH 3RLQWV 
The Stake Points screen in used to locate and stake out points in the
field from coordinates in the job file.
The first two screens of this routine are similar to the conventional
method, except that the
%DFNVLJKW button is replaced with a 6HWXS +5
button to configure rover antenna and the backsight information is
replaced with rover antenna height information. See the
conventional Reference Manual for details.
GPS Staking
This screen is where the measurements take place and the staking
directions are displayed. The graphic display will change depending
on how close you are to the design point. The round icon represents
the rover and the square icon represents the design point. Each
possible screen is illustrated below.
Settings : opens the Measure Mode settings
(Page R-8).
GPS Status : displays the current solution type,
the number of satellites used, and the
horizontal and vertical precision computed by
the receiver. When this area of the screen is
tapped, the epoch count stops and the GPS
Status screen opens (Page R-20).
Go SOUTH / NORTH : displays the distance the
rover must move in a south or north direction
to reach the design point.