Star Water Systems S1101 - Manual (Page 3)

3
ELECTRICAL SHOCK ALERT.
To reduce the risk of electric shock, install only a circuit protected by a ground-fault circuit-interrupter
(GFCI). Make certain that the ground fault receptacle is within the reach of the pump’s power supply
cord. DO NOT USE AN EXTENSION CORD.
ELECTRICAL SHOCK ALERT.
Follow all local electrical and safety codes, as well as the National Electrical Code (NEC) and the
Occupational Safety and Health Act (OSHA).
ELECTRICAL SHOCK ALERT.
Do not kink power cable and never allow the cable to come in contact with oil, grease, hot surfaces,
chemicals or sharp objects. Replace damaged or worn wiring cord immediately.
ELECTRICAL SHOCK ALERT.
As a safety measure, each electrical outlet should be checked for ground using an Underwriters
Laboratory Listed circuit analyzer which will indicate if the power, neutral and ground wires are
correctly connected to your outlet. If they are not, contact a licensed electrician.
ELECTRICAL SHOCK ALERT.
These pumps are supplied with a 3-prong grounded plug to help protect you against the possibility
of electrical shock. DO NOT UNDER ANY CIRCUMSTANCES REMOVE THE GROUND PIN.
ELECTRICAL SHOCK ALERT.
Make sure the pump electrical supply circuit is equipped with fuses or circuit breakers of proper
capacity. A separate branch circuit is recommended, sized according to the National Electrical
Code for the current shown on the pump nameplate.
CHEMICAL ALERT.
This product contains chemicals known to the state of California to cause cancer and birth defects
or other reproductive harm.
WARNING
SAFETY INFORMATION
CAUTION
PRODUCT DAMAGE MAY RESULT
Make certain the power source conforms to the requirements of your equipment.
PRODUCT DAMAGE MAY RESULT
Maximum continuous operating water temperature for standard model pumps must not exceed 130°F (54°C).
PRODUCT DAMAGE MAY RESULT
Do not use an automatic plumbing vent device such as a “Pro-Vent.” Some states require this product to be
installed by a licensed plumber.
• NOTE: Pumps with the “UL” mark and pumps with the “US” mark are tested to UL Standard
UL778. CSA certified pumps are certified to CSA Standard C22.2 No. 108. (CUS.)
• Do not use wax seal that includes a flange that extends into the tank. If a floor is installed over the
tank, use the floor flange extender seal kit included with the system.
• For installation below the original floor line, call 1-800-742-5044.