Sd card slot, Figure 8. sd card slot figure 9. sd card – Allied Telesis Layer 3 Gigabit Ethernet Switch x600-24Ts-POE User Manual
Page 31
x600 Series Layer 3 Gigabit Ethernet Switches Installation Guide
31
SD Card Slot
All of the x600 Series Switches have an SD card slot for storing
configuration files and AlliedWare Plus
Operating System Software image
files on an SD card. See Figure 8.
Figure 8. SD Card Slot
SD cards can make it easier for you to upgrade the files on a switch or
transfer files between x600 switches. See Figure 9.
Figure 9. SD Card
Note
An SD card is not required for normal operations of the switch.
To insert an SD card, position it so that the manufacturer’s brand label is
facing up and press it into the slot until it is flush with the front of the
chassis. To remove the SD card, gently press and release the card. The
SD card will then pop out so you can grasp it with your fingers.
For information on how to transfer files to and from a SD card, refer to the
AlliedWare Plus
Operating System Software Reference Guide.
1616
BUSY
READY
FAULT
SD
1319
SD Memory Card
LOCK