Allied Telesis Layer 3 Gigabit Ethernet Switch x600-24Ts-POE - Manual (Page 87)

x600 Layer 3 Gigabit Ethernet Switch Installation Guide
87
3. Connect the other end of the power cord to an appropriate AC power
outlet. For power specifications for the switch, refer to “Power
Specifications” on page 103.
4. Start a local management session on the unit by performing the next
procedure.
Starting a Local
Management
Session
The following procedure describes how to connect an RJ-45 cable to an
x600 switch. For information about how to log onto the AlliedPlus
TM
Operating System Software, see the AlliedWare Plus Operating System
Software Reference Guide.
To start a local management session on the unit, perform the following
procedure:
1. Connect the RJ-45 end of the management cable included with the
x600 switch to the Terminal Port on the front panel of the switch, as
shown in Figure 47.
Figure 47. Connecting the Management Cable to the RJ-45 Terminal Port
on the Switch
2. Connect the other end of the cable to an RS-232 port on a terminal or
a personal computer with a terminal emulation program.
1320
x600-24Ts/
XP
Layer 3 Gig
abit E
thernet Swi
tch
9 11
13 15 17 19 21R
23R
10 12 14 16 18 20 22R 24R
FAULT
RPS
MASTER
PWR
STATUS
21
22
23
24
SFP
L/A
BUSY
READ Y
FAULT
SD
RESET
CONS OLE