Allied Telesis Layer 3 Gigabit Ethernet Switch x600-24Ts-POE - Manual (Page 71)

x600 Layer 3 Gigabit Ethernet Switch Installation Guide
71
Resetting the Switch
You may need to reset the switch after upgrading the firmware or after you
have made a configuration change that requires resetting the switch to
activate the change.
To reset the x600 switch, perform the following procedure:
1. Locate the RESET button which is on the right hand side of the
faceplate.
2. Press the RESET button with the tip of a pen or a similar
nonconducting object as shown in Figure 33.
Figure 33. Resetting the Switch
1321
x600-24Ts/
XP
Layer 3 Gig
abit E thernet Swi
tch
9 11 13 15
17 19 21R
23R
10 12 14
16 18 20 22R 24R
FAULT
RPS
MASTER
PWR
STATUS
21
22
23
24
SFP
L/A
BUSY
READ Y
FAULT
SD
RESET
CONSOLE