Allied Telesis Layer 3 Gigabit Ethernet Switch x600-24Ts-POE - Manual (Page 33)

x600 Series Layer 3 Gigabit Ethernet Switches Installation Guide
33
Figure 12 shows the port LEDs for the x600-24Ts-POE switch. These
LEDs are located in the upper corners of each port.
Figure 12. Port LEDs on x600-24Ts-POE Switch
Table 3 describes the LEDs for the Base-T ports.
Table 3. Non-PoE Switch Base-T LED Descriptions
LED Function State Description
L/A Link Status
and Activity Off No link has been established between
the port and the end node.
Solid
Green The port has established a link at
1000 Mbps.
Flashing
Green Packets are being received or
transmitted at 1000 Mbps.
Solid
Amber The port has established a link at 10
or 100 Mbps.
Flashing
Amber Packets are being received or
transmitted at 10 or 100 Mbps.
D/C
1 Duplex
Mode and
Collisions Solid
Green The port is operating in full-duplex
mode.
Solid
Amber The port is operating in half-duplex
mode (only applies when operating at
10 or 100 Mbps).
Flashing
Amber Collisions are occurring on the port
(only applies when operating at 10 or
100 Mbps, half duplex mode).
LINK/ACT
1467
PoE
LED
PoE
LED LINK/ACT
LED
LED