GW Instek PSW-Series User Manual - Manual (Page 76)

PSW Series User Manual
76
Master-Slave Parallel Connection
Master-Slave
Connector The Analog Control Connector is used for both
serial and parallel connections. The way the
connector is configured determines the
behavior of the master and slave units. For the
complete connector pin assignment, see page
117.
Analog Connector
Connection To operate the power supplies in parallel,
connect the analog connectors on the master
and slave units as shown in the diagrams
below.
Alternatively pre-configured cables (optional)
can be used. The PSW-006 is used for two units
in parallel. The PSW-007 is used for 3 units in
parallel.
Master with 2 slave units:
12
13
14
15 17
20
21
24 20 12
17 15 3 17 15
3 12 24 20
11 1 2 1
OUTPUT ON STATUS 21
Master unit
ALM STATUS 20
STATUS COM 17
FEEDBACK 15
CURRENT_SUM_1 13
SHUTDOWN 12
OUT ON/OFF CONT 24
Slave Unit 1
12 SHUTDOWN
20 ALM STATUS
15 FEEDBACK
3 CURRENT SUM OUT
Slave Unit 2
OUT ON/OFF CONT 24
12 SHUTDOWN
17 STATUS COM 17 STATUS COM
2 D COM
15 FEEDBACK
CURRENT_SUM_2 CURRENT SUM OUT 3 14
20 ALM STATUS
11 1 1 I MON CURRENT SHARE CURRENT SHARE