GW Instek GDS-800 Series Programming Manual - Manual (Page 41)

GDS-806/810/820/840 Programming Manual
40
:GONogo:SOURce (Available for firmware 2.0 and above only)
Sets and query the user-defined GO/NO-GO comparison source channel.
This command is equal to the function key “F2” pressing of GO/NO-GO menu.
Syntax
:GONogo:SOURce {1|2}
:GONogo:SOURce?
Arguments
1 →Select CH1 to be the comparison
source.
2 →Select CH2 to be the comparison
source.
Returns
<NR1>
Note: Before running any Go/NoGo commands, the oscilloscope has to be initialized, please
add the command of “:GONogo:FUNCtion 1” in order to initial the oscilloscope.
:GONogo:VIOLation (Available for firmware 2.0 and above only)
Sets and query the user-defined GO/NO-GO violation conditions. This command is
equal to the function key “F3” pressing of GO/NO-GO menu.
Syntax
:GONogo:VIOLation {0|3}
:GONogo:VIOLation?
Arguments
0 →Stop 1 →Stop + beep
2
→Continue 3→Continue + beep
Returns
<NR1>
Note: Before running any Go/NoGo commands, the oscilloscope has to be initialized, please
add the command of “:GONogo:FUNCtion 1” in order to initial the oscilloscope.