2 addressing explanation and examples – In-Situ Aquaculture Buoy Manual (purchased before 28 May 2013) User Manual
Page 14
Advertising
14
Buoy Transceiver
FIGURE 8. Transceiver interior
4.2.2
Addressing Explanation and Examples
Switches 1 through 7 have a binary value. These values are shown in
the table below:
By adding all the values of the switches that are in the “ON” position,
you can determine the address.
1
Probe connection—red wire
2
Probe connection—green wire
3
Probe connection—blue wire
4
Probe connection—black wire
5
Probe ground—silver wire
6
Power 9–18 volts DC +
7
Power9–18 volts DC –
8
Radio module with integrated antenna
9
Transceiver addressing dip switches
Switch
Value (if in the “ON”
position)
1
1
2
2
3
4
4
8
5
16
6
32
7
64
8
128
Advertising
This manual is related to the following products: