In-Situ Level TROLL 400/500/700/700H Operators Manual - Manual (Page 48)

1-800-446-7488 48 www.in-situ.com
Sensors Tab
The Sensors tab lists the sensors in the instrument, along with their serial numbers and
calibration dates. Use the buttons in this tab to calibrate and configure sensors.
Calibrate
Use the Calibration button to calibrate sensors or to adjust a level reference that is
currently stored on the instrument. The Calibrate button is not available when the
instrument does not support calibration (e.g. BaroTROLL Instrument).
1. With the instrument connected to the software, select the Sensors tab.
2. Select the parameter you intend to calibrate.
3. Click the Calibrate button .
Configure
Use the Configure button to select parameter units and to configure parameters that
support configuration. Examples include Level/Depth, Specific Conductivity, and Total
Dissolved Solids. Parameters cannot be configured while the instrument is showing
live data on the Home screen or while the instrument contains an active log.
1. With the instrument connected to the software, select the Sensors tab.
2. Select the parameter you intend to configure.
3. Click the Configure button .
When you configure the Level parameter using the Sensors tab,
the settings are stored in the instrument and are available for use
in Modbus, SDI-12, or analog communication. If desired, a
different configuration can be selected when setting up a log.