Disconnecting an instrument from the software, 9 connect to a data logger or plc controller, Connect to a data logger or plc controller – In-Situ Level TROLL 400/500/700/700H Operators Manual User Manual
Page 59
1-800-446-7488
59
www.in-situ.com
Disconnecting an Instrument from the Software
Click the plug icon
in the lower-right corner of the screen to disconnect the
instrument from the software.
Disconnect the instrument from the TROLL Com Communication Device. Attach a
desiccant pack if you are using a vented cable.
Connect to a Data Logger or PLC Controller
The instrument can be connected to a data logger or controller via a stripped-and-
tinned RuggedCable System for communication using one of the following protocols.
l
Analog (4-20 mA)
l
SDI-12
l
RS485 Modbus
l
RS232 Modbus (with a customer-supplied converter)
Stripped-and-tinned RuggedCable System includes a female connector on one end
that connects to the instrument. The uphole end terminates in stripped-and-tinned wires
for connection to a PLC controller or data logger.
A shorter length Stripped-and-tinned RuggedCable System with a male connector is
available to convert a female to female RuggedCable System to a stripped-and-tinned
configuration.