5 adjust communications outputs, 6 modbus setup, Adjust communications outputs – In-Situ Communication Device Kit for the Aqua TROLL 400 and RDO PRO Probe User Manual
Page 4: Modbus setup
Advertising
800-446-7488
4
www.in-situ.com
Adjust Communications Outputs
The Communication Tab allows you to configure your instrument to communicate via
Modbus or SDI-12 protocols. The instrument can use only one of the protocols at a time.
Modbus Setup
Click the Modbus setup button and assign instrument settings according to the
requirements of your controller. For instrument Modbus registers, see the Aqua
TROLL
®
400 Modbus and SDI-12 Reference Guide.
Advertising
This manual is related to the following products: