KANOMAX 6006 Anemomaster LITE - Manual (Page 13)

12 Troubleshooting
§ 5 Troubleshooting
Before asking for repair, check the items below.
1. Under normal conditions:
Problems Possible Cause Corrective Action
No power.
(LCD remains unlit)
Dead batteries.
Replace them with new
batteries.
Wrong battery polarity. Insert them correctly.
Dirty contact point.
Clean the contact point of
the battery.
“----” (OVER) is
displayed.
Used beyond the
measurement range. Use it within the
measurement range.
Air velocity sensor is
damaged.
Contact the dealer.
“E01” is displayed or
“0.00” display
remains unchanged.
Air velocity sensor is
damaged.
Contact the dealer.
Probe cable is damaged. Contact the dealer.
“E02” is displayed.
Air temperature sensor is
damaged.
Contact the dealer.
Display frozen.
Display is “paused”. Release “pause”.
Weak batteries.
Replace them with new
batteries.
Display goes on and
off.
Weak batteries.
Replace them with new
batteries.
Dirty contact point.
Clean the contact point of
the battery.
Unit of the readings is
different.
Unit setting has been changed.
Change the unit using the
dip switch in the battery
case.
2. When replacing the probe:
Problem Possible Cause Corrective Action
“E01” is displayed or
“0.00” display
remains unchanged.
Connector is not connected
correctly.
Turn the power off and
re-connect the connector.
Probe was replaced while the
power was on.
Turn the power on again.
3. When replacing the batteries:
Problem Possible Cause Corrective Action
No power.
Batteries were replaced while
the power was on.
Remove all the batteries
and insert them again.