KANOMAX 6006 Anemomaster LITE - Manual (Page 4)

iii
Do not subject the instrument or the probe to strong impacts.
Dropping the unit or placing heavy objects on it may cause damage
or malfunction to the instrument.
Never disassemble, modify or repair the product.
Failure to observe the above may cause short circuit and/or other
failure that will affect the performance.
Do not pick up or carry the instrument by the probe cable.
It may cause a malfunction or the wire may break.
Remove the batteries from the battery compartment when
storing the instrument. Do not leave exhausted batteries in the
battery compartment. When inserting batteries be sure to
insert them with the polarity facing the correct direction.
Failure to do so may cause battery leakage.
Do not wipe the instrument with a volatile solvent.
The body may deform or deteriorate. Use a soft dry cloth to remove
stains. If stains persist, soak the cloth in a neutral detergent and
wipe the instrument with the soft cloth. Never use volatile solvents
such as thinner or benzene.
Discharge any built-up static electricity from your body before
touching the instrument.
The built-up static electricity may influence the readings and cause
damage to the circuit.
Regularly check the head of the probe for contamination.
Impurities (such as dust) on the sensor may affect the
accuracy of the measurements.
To get rid of dust, use a blow blush for cameras to blow it off, or you
can rinse it with water and allow it to air-dry completely.
*Be sure to turn the power off before you clean it.
*Never dry the probe with heat. (Heat may cause permanent damage
to the sensor.)
Do not remodel/
disassemble
Electrified
Forbidden
Forbidden
Forbidden
Forbidden
Forbidden
Use properly
Use properly