KANOMAX 6006 Anemomaster LITE - Manual (Page 9)

8 Preparation for Measurement
§ 2 Preparation for Measurement
Installing Batteries
 Use four AA size batteries.
 Make sure that the power is off before inserting the batteries.
 If you are using charging batteries, charge them with a special
charger prior to use.
＜Back (Battery Case)＞
1. Slide the cover of the battery case down
along the rail.
2. Slide the cover until it stops, and then lift it
up.
3. Insert the batteries in the order shown in
the left figure, observing polarity.
4. Replace the battery cover by following the
reversed procedures 1 and 2.
To put the battery cover back,
do not first engage the detent
at the top end.
Follow the above-mentioned
procedure backwards to slide
the cover back.
If you forcibly try to click the
cover onto the body, it may
be broken.
＋
-
-
-
-
＋
＋
＋
２ １
３ ４