KANOMAX 6162 Anemomaster - Manual (Page 11)

1. Getting Started 5
1.4 Power Source
1.4.1 Battery Replacement
<<CAUTION>>
Make sure the polarity is right.
Install the batteries by observing the polarity. If not, it may cause malfunction due to short-circuit or
heatup.
Install the batteries properly following the directions indicated on the bottom of the battery compartment.
1.4.2 AC Adapter
When the AC adapter is connected, it has a priority. It does not cause any problems
even if the batteries are still installed. However, if you do not use the instrument for a
prolonged time, remove the batteries. Otherwise, it may cause the contact failure due
to the battery corrosion.
<<CAUTION>>
Use our designated AC adapter.
Other AC adapters on the market place may have different polarity.
=> It may cause short circuit or fire.
MODEL 6113-02
INPUT: 100-240VAC 50-60Hz
OUTPUT: 9VDC 2A
Connector
AC Adapter
* Insert the middle batteries at last after placing the
batteries at the both sides.
Make sure to place the tape under the battery as shown in
the above picture.
3. How to Install Batteries
1. How to Open the Battery Cover
Push the click up towards the
arrow direction to remove the lid.
2. How to Remove the Batteries
Pull the tape up.