KANOMAX 6162 Anemomaster - Manual (Page 17)

2. Basic Operation 11
2.4 Remaining Battery Level
Display Key Procedure
BATT Press BATT key.
★ The remaining battery capacity level will be displayed for 2
seconds. Then the screen will go back to the original screen
automatically.
* Voltage for a new dry cell battery is 9V.
* Voltage for a fully charged Ni-Cd battery is about 8.5V.
2.4.1 Battery Level Indicator
Š When the remaining battery level becomes lower than 6V, the display screen
will start blinking.
Please note that the reading when the screen is blinking cannot be
guaranteed.
* Once the voltage of Ni-Cd battery becomes 6.5V or lower, the voltage
will decrease at a rapid pace. Charge the batteries ahead of time.
* Using backlight drains battery quickly. Please use the backlight only
when necessary.
This feature is available only on the monitoring screen or
when the instrument is ready for a measurement in the
measurement mode (when “ready” is displayed). On other
screens this feature cannot be used.
08.07.01 FAST
10:26:40
5.38 m/s
25.7 ℃
08.07.01 FAST
10:26:40
5.38 m/s
25.7 ℃
Change the batteries when
the screen starts blinking.
When the remaining battery
capacity level becomes lower:
PLEASE
CHANGE BATTERY
08.07.01 FAST
10:26:40
5.38 m/s
25.7 ℃
blinking
remaining battery capacity level
Voltage (V) 6 7 8 9
<BATTERY CHECK>
BATTERY CHANGE
VOLTAGE 6V
6 7 8 9