KANOMAX 6162 Anemomaster - Manual (Page 49)

8. Troubleshooting 43
8.3 During a Measurement
No. Symptom Possible Cause / Solution Refer to
The displayed measurement value is
abnormal.
1.
Ex) Air Velocity:
Air Temp:
**.*
0.0
- If a measurement is performed out of the spec
range, “over” will be displayed on the screen.
- Probe sensor may be damaged.
2.
While measuring, the display screen
starts blinking. - The batteries are drained.
⇒
Need new batteries.
Page 11
3.
Data cannot be stored in the internal
memory. - Setting has not been configured properly.
⇒
MEMORY YES
Chapter
3
4. The response of the reading is slow.
- Moving average deviations is selected.
⇒
FAST/SLOW key
Page 9
8.4 Analog Output
No. Symptom Possible Cause / Solution Refer to
1. No output.
- Output only on the initial screen or when
measuring in the measurement mode?
- The screen is on hold.
2. The output value is wrong. - The output range is wrong.
Page 30
8.5 Digital Output
No. Symptom Possible Cause / Solution Refer to
1. DEVICE ERROR is displayed. - The cable’s wire connection is not correct. Page 34
2. Data cannot be collected.
- The host computer’s setting is not properly
configured.
- Baud rate setting is not correct.
Page 32
3. Data is wrong. - Output format is not correct.
Page
33, 35
8.6 Printer
No. Symptom Possible Cause / Solution Refer to
1. The printer turns OFF while printing. - The printer’s NiCd battery is drained.
2. Cannot take a hardcopy of the screen.
- The screen may not be on hold.
⇒
Put the screen on hold.
- You may be trying to take a hardcopy while
measuring.
⇒
After the calculation, try again.
Page 13
Chapter
4
3.
There is not print output after
calculation. - Setting has not been configured properly.
⇒
PRINT YES
Chapter
4