AT&T System 25 - Manual (Page 75)

Transfer ✓
❑
If you use
TRANSFER
on the SLAC to extend calls, unanswered
and busy calls will not be returned to your console and may be
lost .
When you transfer a call, the original person is temporarily
placed on hold and is not connected to the other person until
you hang up. At that time, the call disappears from the
telephone.
Transferring Calls
1
2
3
Press
TRANSFER
and listen for dial tone.
The light next to
Dial the other
as
DSS
.
the button of the call on hold blinks intermittently.
person’s extension or press a line button, such
NOTE: If you misdial the number, return to the person on
hold by pressing the button next to the blinking light. Then
return to Step 1 and continue.
Hang up if you do not want to announce the call.
Otherwise, announce the call and then hang up to complete
the transfer.
NOTE: If the person you attempt to call does not answer,
press the button next to the blinking light to return to the call
on hold.
NOTE: Do not use the
RELEASE
button with this procedure,
or you will disconnect the call.
NOTE: You can transfer some calls to outside lines.
However, you should see your System Administrator for
more information about this type of transfer.
71