KROHNE OPTIWAVE 6300C EN - Manual (Page 24)

3
INSTALLATION
24
OPTIWAVE 6300 C
www.krohne.com 03/2014 - 4000547004 - HB OPTIWAVE 6300 R04 en
If the antenna is smaller than the process connection:
• Make sure the silo connection is level.
• Make sure that you use the applicable gasket for the connection dimensions and the process.
• Align the gasket correctly.
• Lower the antenna carefully into the silo.
• Turn the threaded connection on the housing to attach the device to the process connection.
• Tighten the connection.
i Refer to local rules and regulations for the correct torque to apply to the connection.
Equipment needed:
• 3 mm Allen wrench (not supplied)
Requirements for threaded connections
Figure 3-10: Threaded connection
Figure 3-11: How to attach the device if the antenna is larger than the process connection