KROHNE Summit 8800 Vol 1 - Manual (Page 95)

95 www.krohne.com
08/2013 - MA SUMMIT 8800 Vol1 R02 en
SUMMIT 8800 CONFIGURATION SOFTWARE 10
Figure 108 Menu Configurator software
10 .1 .2 Select the preferred engineering units
Normally, the default engineering units will be Metric. However it is possible to set the default
units for the configurator to USC.
Start the configurator, then:
Select settings and tab “Users”:
Figure 109 Appearance
Select the default engineering units (metric or USC) and press OK.
10 .1 .3 Install an additional user
Multiple users can be given access to the configuration software, each with their own name and
password and each with their specific access levels.
On top of this, it will be possible to restrict the access to running software modules by configura-
tion. See Volume 3, General Information: Security Configuration.