KROHNE MFC 400 EN - Manual (Page 78)

6
OPERATION
78
MFC 400
www.krohne.com 08/2013 - 4002075802 - MA MFC 400 R02 en
C3._.11 Phase Shift w.r.t. B Only available when configuring the terminal A or D and only if output B is a
pulse or frequency output. If setting in Fct. C2.5.6 is "Both Polarities", the
phase shift is prefixed by a symbol, e.g. -90° and +90°
Select:
Off (no phase shift) /
0° Phase Shift (between outputs A or D and B, inversion possible) /
90° Phase Shift (between outputs A or D and B, inversion possible) /
180° Phase Shift (between outputs A or D and B, inversion possible)
C3.3.11 Special Functions This function is only available at the pulse output of terminal B. At the same
time, 2 pulse outputs must be available:
1st output at terminal A or D / 2nd output at terminal B
The B output is operated as a slave output, controlled and set using master
output A or D
Select:
Off (no phase shift) /
Phase Shift w.r.t. D or A (slave output is B and master output is D or A)
C3._.12 Information Serial no. of the I/O board, software version no. and production date of the
circuit board
C3._.13 Simulation Sequence see B1._ Pulse Output X
.book Page 78 Monday, August 26, 2013 9:05 AM