KYORITSU 6305 Quick Manual - Manual (Page 22)

− 21 − KEW6305
KEW6305 Demand Measurement : DEMAND Range
8. Demand Measurement : DEMAND Range
8-1. Steps for measurement
Ensuring your safety
↓
Preparation for measurement
↓
Setting
↓
Wiring
↓
Demand measurement
* Measured demand values will be displayed on the LCD at the start of measurement.
● Parameters for DEMAND Range
Parameters to be displayed on the LCD Unit
Target value W
Predicted value W
Present value W
Load factor %
Demand time −
Max. demand value W
When max. demand value measured −
SET UP Range
Basic Setting Measurement setting
“ Setting 01” Wiring system“Setting 09” Recording interval
“ Setting 02” Voltage range “Setting 10” Specifying rec. period or endless rec.
“ Setting 03” Clamp sensor “Setting 11” Time period setting Time setting
“ Setting 04” Current range“Setting 12” Time period setting Date setting
“ Setting 05” VT ratio
(if necessary)“Setting 13” Start of continuous measurement
“ Setting 06” CT ratio
(if necessary)“Setting 14” End of continuous measurement
“ Setting 15” Target demand
“ Setting 16” Demand measurement cycle
“ Setting 17” Demand warning cycle
Range