Martel Electronics BetaGauge 321A - Manual (Page 37)

ERROR _ MODE?
Returns the current state of percent error mode.
For example:
If you send ERROR_MODE? It will return ON if the calibrator is in percent error
mode.
ERROR_ PORT
Sets the pressure port for percent error.
For example:
To set the pressure port for percent error to [P1] send ERROR_ PORT P1.
ERROR _ PORT?
Returns the current pressure port for percent error mode.
For example:
If you send ERROR _PORT?, it will return P1 if the pressure port in percent
error is [P1].
FUNC
Sets the display indicated in argument one to the function indicated in argument 2.
For example:
To set the lower display to RTD mode send FUNC LOWER,RTD.
FUNC?
Returns the current mode of all displays. For example if the calibrator is set to [P2]
ST on the upper display, [P1] on the middle, and RTD on the lower, FUNC? Would
return:
ST_P2,P1,RTD
HI_ERR
Sets the 100% point for the percent error mode calculation in the current engineering
units.
For example:
To set the 100% point to 100 psi send HI_ERR 100.
HI_ERR?
Returns the 100% point for the percent error mode calculation.
For example:
If the 100% point is set to 100 psi, HI_ERR? would return 1.000000E+02, PSI .
LOCAL
Restores the calibrator to local operation if it was in remote mode. Also clears
LOCKOUT if the calibrator was in lockout mode.
35