001 v, 000 ma, Using measure modes – Martel Electronics MC1010 User Manual
Page 12: Volts in menu, Light, Ma in -25.00% menu, 1 measuring volts and frequency, 2 measuring ma
12
3. Using Measure Modes
3.1 Measuring volts and frequency
The calibrator can measure volts or frequency on these jacks. To make the desired
measurements, follow these steps:
1.
Select the [CONFIG] option from the main menu.
2.
Select the desired parameter for measurement.
3.
Connect leads as shown in Figure 5.
Figure 5. Measuring Volts and Frequency with Input/Output Terminals
3.2 Measuring mA
To measure mA follow these steps:
1.
Select the [CONFIG] option from the main menu.
2.
Choose [mA] from the primary parameters.
3.
Make sure the input/output control is set to IN.
4.
Connect leads as shown in Figure 6.
Figure 6. Measuring mA with Input/Output Terminals
VOLTS IN
MENU
-0.001 V
LIGHT
MEASURE / SOURCE
3W
mA+
TC
+
V
Hz
–
Ω
4W
mA–
–
+
MEASURE / SOURCE
3W
mA+
TC
+
V
Hz
–
Ω
4W
mA–
–
+
mA IN
-25.00%
MENU
0.000 mA
LIGHT