Martel Electronics MC1010 - Manual (Page 29)

Command Description
FREQ_TYPE Set the frequency output to continuous (frequency) or pulse.
FREQ_TYPE? Returns frequency output type, continuous or pulse
FREQ_UNIT Sets the unit for frequency and pulse
FREQ_UNIT? Returns the unit for frequency and pulse
FUNC? Returns the current mode of the calibrator
LOCAL Returns user to manual operation of the calibrator
LOCKOUT Locks out the keypad of the calibrator, and allows for remote operation only
MEAS Sets the mode for measuring of the calibrator
PRES_UNIT Sets the pressure unit of the calibrator
OUT Sets the output of the calibrator
OUT? Returns the output of the calibrator
PRES? Returns the model and serial number of the attached pressure module
PRES_UNIT? Returns the pressure unit for the calibrator
PULSE_CNT Sets the number of pulses for the pulse train
PULSE_CNT? Returns the number of pulses in the pulse train
REMOTE Puts the calibrator in remote mode
RTD_TYPE Sets the RTD type
RTD_TYPE? Returns the RTD type
RTD_WIRE Sets the number of wires used by the RTD mode.
RTD_WIRE? Returns the wire number setting used in the RTD mode
SIM Sets the output for mA simulation
SIM? Returns the output of the mA simulation
TEMP_UNIT Sets input/output temperature unit for RTD and TC
TEMP_UNIT? Returns the temperature unit for RTD and TC
TRIG Starts and stops the pulse train in pulse mode
TRIG? Returns TRIGGERED when a pulse train is on. Returns UNTRIGGERED when the pulse
train is off.
TSENS_TYPE Sets temperature sensor type.
TSENS_TYPE? Returns temperature sensor type
VAL? Returns the measured values
ZERO_MEAS Zeros the pressure module
ZERO_MEAS? Returns the zero offset of the pressure module
29